Brultech Greeneye Monitor User Manual download pdf (Page 8)

Connecting Directly to the GEM

CONNECTING DIRECTLY TO THE GEM

IMPORTANT NOTE

This chapter describes the procedure for creating a WiFi connection between the GEM and a PC. The

main purpose of this connection is to configure the GEM to connect it to a network.

If a PC with WiFi capability is not available, an Ethernet connection may be used for this step, although

this method is a bit more tedious. Refer to Appendix A for instructions on using Ethernet for initial

configuration.

Make sure there is no Ethernet cable connected between the GEM and a network when conducting

the steps in this chapter.

FACTORY DEFAULT VALUES

Once the communication module has been reset to its factory defaults, a WiFi connection may be

established between a PC and the GEM.

The factory default settings are:

 Set to Access Point (AP) mode

 DHCP enabled. The server will assign an IP address to the PC, providing the PC is set to obtain an

IP address automatically

 The SSID is “GreenEye_xx”, where xx is the last two digits of the MAC address

 WiFi security mode “Open”

 Local IP address: 192.168.2.2

 Network setup port 80

 GEM setup port 8000

CONNECTING TO THE GEM VIA WIFI

The goal is to create a connection between the PC and the GEM as shown in Figure 5.

Figure 5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

No comments

Brultech Greeneye Monitor User Manual Page 8